Hi, I have not followed the thread, but have you checked that the square end of the wire disappear when you connect the ground symbol?
Do not connect the ground symbol directly to a pin, put wire between them. Pedro. > Any other ideas to get the ground symbol to connect to the circuit? > > --- In [email protected], "martin_de_la...@..." <de_la...@...> wrote: > > > > Yes I did connect to the centre of the hor line > > > > > > --- In [email protected], Robert <birmingham_spider@> wrote: > > > > > > The ground symbol is a bit weird in that it doesn't have a salient pin. > > > Did you connect a wire to the centre of the horizontal line? > > > > > > Regards, > > > > > > Robert. > > > > > > martin_de_lange@ wrote: > > > > In the schematic capture some junction shows the non connected flag > > > > when I run the ERC. I used only the supplied library and worked on > > > > the 50 grid. In the netlist I can also see some are not connecting > > > > and the consistent culprit is the ground symbol. Any ideas please? > > > > > > > > > > > > > > > > ------------------------------------ > > > > > > > > Please read the Kicad FAQ in the group files section before posting > > > > your question. Please post your bug reports here. They will be picked > > > > up by the creator of Kicad. Please visit http://www.kicadlib.org for > > > > details of how to contribute your symbols/modules to the kicad > > > > library. For building Kicad from source and other development > > > > questions visit the kicad-devel group at > > > > http://groups.yahoo.com/group/kicad-develYahoo! Groups Links > > > > > > > > > > > > > > > > ------------------------------------------------------------------------ > > > > > > > > > > > > > > > > No virus found in this incoming message. Checked by AVG - www.avg.com > > > > Version: 8.5.287 / Virus Database: 270.12.8/2086 - Release Date: > > > > 04/29/09 06:37:00 > > > > > > > > > > > >
