I have run across a strange problem. I am very much open to chair-keyboard interface being the problem.
I have a board that has two adjacent edge connectors separated by about an inch. These two connectors are tied together in the schematic. I have run across a couple of problems: 1. When I run the autorouter, it routes the traces completely outside the edges of the board! I *THINK* I have the PCB edges set properly and it appears to be correct, but it still routes traces off the board. Any ideas why this could be happening?? 2. The module editor insists on creating the attachment point in the center of the connector instead of at one end. Is there a setting to indicate that the trace connection should be at the inboard end of the "finger" instead of the middle? Thanks, Greg
