--- In [email protected], "gregory.dyess" <gregory.dy...@...> wrote: > > I have run across a strange problem. I am very much open to chair-keyboard > interface being the problem. > > I have a board that has two adjacent edge connectors separated by about an > inch. These two connectors are tied together in the schematic. I have run > across a couple of problems: > > 1. When I run the autorouter, it routes the traces completely outside the > edges of the board! I *THINK* I have the PCB edges set properly and it > appears to be correct, but it still routes traces off the board. > > Any ideas why this could be happening?? > > 2. The module editor insists on creating the attachment point in the center > of the connector instead of at one end. > > Is there a setting to indicate that the trace connection should be at the > inboard end of the "finger" instead of the middle? > > Thanks, > Greg >
This may not be a solution but a workaround for you. Have you tried to manually route the two connectors together and then autoroute the rest of your pcb board.
