--- In kicad-users@yahoogroups.com, "Dan" <dan...@...> wrote:
>
> I do this all the time; it's pretty simple. Just make your schematic
> changes, but when you annotate your components, only annotate the new ones;
> don't change the designations on the ones which are staying the same, or else
> you'll have to re-layout your board, or change the designators on the board
> all by hand to match.
>
I assume that I had better not re-use any designations for components that I
omit either? Ie if the last resistor is R20, then I continue from R21 even if
R18 and R19 are gone?
