Hi, Usually this type of error is due to a different pin numbers in the component (eeschema) and the module (pcbnew).
Check if pins are numbered, for example, 1,2,3 in the component and A,B,C in the module. Pedro. > I'm working on a dual H-Bridge motor controller Arduino shield. I have the circuit complete in EESchema and the ERC is happy and all that good stuff. In PCBnew, I'm able to import all my components by reading the netlist, but not everything is connected by the rat nest. > > Interestingly enough, its only the MOSFETs that didn't get connected. Eight TO220 and four TO92. Everything else seems to be connected correctly. > > Any ideas? I'm very new to KiCad (been using it for a whole 8 hours now), so it's very likely I've just done something wrong. I can post screenshots if that would help. Thanks! > >
