I have the same problem, I can fill zone without problem on XP and windows2000, but occasionally it crashes on Vista.
What I did is delete all the zone definition or go back till the nearest good one and then redraw the zone. Wei --- In [email protected], "hal8000b" <hal80...@...> wrote: > > > > --- In [email protected], "andrwpodm" <andrwpodm@> wrote: > > > > Ok. I had this problem before but after searching the messages for a > > possible solution I thought I had found it, but to no avail. Everytime I > > create a zone and then try to fill it, PCBNew crashes.I have tried setting > > the dimensions in inches and not mm, and left the clearance at 0.02" as > > stated in a previous post. It worked a few times, but now its started all > > over again. I am running Windows Vista Home Premium Edition and Kicad build > > 20090216 final. > > > > Any suggestions?????? > > > > Andy > > > > You're not going to like me answer, unless anyone else can verify. > > There are no problems with Windows XP filling zones so I feel this may be > down to Vista. Unfortunately being run on windows, there is no further help > to what causes this. > You could try updating your graphics card drivers, as its a fill routine, it > may be graphical related. Other than that have you tried a different version > of kicad? >
