Marc, I did not completely understand what you meant by "suppress both grounding zones". So I deleted the only zone I had created and created a very small zone surrounding just the GND pin on J1. It still crashed trying to fill it.
I tried the second method too and it still crashes trying to fill it. I could not try the third method as my circuit is a very simple example circuit and has no vias. I will try the to get Ubuntu and see if that works better. Thanks for the tips Regards yukku ________________________________ From: marc olanié <[email protected]> To: [email protected] Sent: Thu, December 31, 2009 9:01:45 PM Subject: [kicad-users] Pcbnew crash while filling a zone Hi Yukku Don’t worry… you’re not alone :- ) This “bug” (I will call it a bug as it seems difficult to qualify it as a “feature”) is a very strange one. It seems to appear on vista and Win7 platforms –but I never used kicad under windows XP). You have 3 ways to circumvent it First method : totally suppress both grounding zones, and recreate an upper and a lower grounding zone but far smaller than the size of your pcb. Fill these zones, and then use the “summit drag and drop” function to resize the grounding zone to the right area and dimensions. Second method : kill your pcb perimeter (the yellow contour) and define a new one with slightly different dimensions (you’ll have to readjust these drawing later) and redraw your new filling zone with the exact size you initially intend. Third one : use the second method an suppress all the grounding vias at the same time. Don’t ask me why, but I had this frustrating bug several time and couldn’t find a precise answer on this mailing list. It could look a little bit “shamanic” but it works The first method don’t seems to work every time. Marc A good working kernel doesn't allow a program crash unless it says “please” Traduction : Da Power Fantudjû, RuleZ Tartiflette [Attachment(s)from yukku yukkoooooo included below] Hi Andy and all, I followed the procedure given in the Pcbnew help .pdf file, and I still get a crash while trying to fill the Ground zone on a 2 layer board. I am attaching the .brd file in this mail. It was saved just before attempting the refill. Can you open it and see what I have not done right ? Sorry if this is some more newbie issues. Thanks for the help yukku
