If you are looking for approval I doubt you would get it here. No one wants to be included in a bad decision even if it was unintentional. Rather than redrilling the wafs, have you tried measuring for any discrepancy in them? Did you make them yourself? A difference of .030 on hole location would make a big change if you took them off and swapped them around. If you made them yourself you would know they are not that hard to make. Maybe try to just make the couple with the needed changes to put the tips where they need to be?
Steve McGee Endeavor Wi. USA Building a KR2S widened. [email protected] ----- Original Message ----- From: <[email protected]> To: <[email protected]> Sent: Sunday, January 18, 2004 8:04 PM Subject: KR>WAF'S OVER SIZED BOLTS > Guys, > > When I drilled up my WAF'S the tips of the forward spars were in different > places. I need to bring the right wing tip forward and the left wing tip aft. I > was thinking about taking the bolts (AN6's) out of the upper and lower attach > fittings on the rear face of the forward spar, moving them to where the should > be and, reaming the holes up to a 7/16 (AN7), which should clean up any > mismatch. This would put me below the 2D minimum for edge distance by .072 in. > > Chris Theroux > Gilbert, AZ > _______________________________________ > to UNSUBSCRIBE from KRnet, send a message to [email protected] > please see other KRnet info at http://www.krnet.org/instructions.html > >
