Ray,
I used Permatex High-Temp RTV Silicone 26B. around the outside edge to
hold the SS steel to the Fiberfrax. It is good for 650 deg. F. It just has
to hold things in plae until you get the motor mount bolted on. Later I cut
the fiberfrax back about 1/8 inch then mixed up some resin and flox and
filled it in. When cured. sand it down. It makes a clean edge.
Jim Morehead
Cameron Park, CA
on 5/2/04 1:06 PM, [email protected] at [email protected]
wrote:
> I say up front that I have not checked the RR handbook lately. I will
> be putting the Firewall together in the near future and I am checking on
> bonding agents. I plan to use T88 fot the wood to wood---Fiberfrax cement for
> wood
> to fiberfrax----and ???? for St. Stl. to Fiberfrax. Any suggestions and /or
> comments? You may reply on the following E-mail address.
> Ray Goree Arlington, Tx.
>
> [email protected]
> _______________________________________
> to UNsubscribe from KRnet, send a message to [email protected]
> please see other KRnet info at http://www.krnet.org/info.html
