Reduce your approach speed !! If it wanted to fly at 60, then
approach near there.
 Your choice of speed, not mine, Virg

On Mon, 6 Nov 2006 20:16:07 +0200 "Willie van der Walt"
<touri...@intekom.co.za> writes:
> Today was the 4th flight with "shreg" and it ended in the felt on the 
> extended runway. I came in on finals and did a side slip in a 75 
> degree X-wind. The speed was down to 90 mph when I crossed the fence 
> and I was about 1m above the runway over the numbers. I was hoping 
> to loose the extra 10 mph but no way. The throttle was closed at 
> idle about 1000 rpm but the plane kept on floating. I then put the 
> wheels onto the runway and held it firmly on the ground. The speed 
> was indicating 60 while running with the tail up. There was still 
> about 600m of runway left. I pulled back slightly to apply brakes 
> but then the wheels hardly touched the ground and I could feel The 
> KR wanted to get airborne again. At 40mph I could pull back on the 
> stick and apply enough brakes to almost lift the tail. I had no 
> direct forward visibility over the nose and was shocked to see the 
> loop entrance, at the holding point, coming past at about 20mph. I 
> went off the tar into the long grass and almost flipped over as the 
> grass grabbed the wheels, spats and wings all at the same time. This 
> was a quick stop. Even the engine stopped. Hennie repaired the prop 
> well because the tips held up well against the grass. Only some 
> marks on the red tip paint. I pushed the plane back to the hanger 
> and left it there for the night as I had enough excitement for one 
> day.
> 
> In summery. I need to get the speed down to 80 over the fence or go 
> around and try again if I am still above over the numbers. Wish I 
> could fit airbrakes like we had on the gliders when I sailed at 
> Donaldson Dam.
> 
> If I can not get landings right within the next 3 or 4 times I am 
> going to fit a belly plate brake or something. 
> 
> What can I do to loose the lift after round out?
> 
> Regards Willie www.riversafaris.co.za
> 
> touri...@intekom.co.za
> 
> 
> 
> 
> 
> 
> 
> 
> 
> 
> 
> 
> 
> 
> 
> 
> _______________________________________
> Search the KRnet Archives at 
> http://www.maddyhome.com/krsrch/index.jsp
> to UNsubscribe from KRnet, send a message to krnet-le...@mylist.net
> please see other KRnet info at http://www.krnet.org/info.html
> 
> 

Reply via email to