Sorry I should have been more clear and actually my reasons . I have a very well made composite spinner in my shop. I have checked it for balance and true and it is great. It was made that bulk heads (forward and aft) like the ones from ACS (i think they were part # SN-1 or something like that) would have fit in pretty dang close. I am not real keen on a composite bulk head from the way to many times that I have fooled with prop balancing. I am not convinced that I am capable of laying up carbon fiber ones that are consistent to keep the weight concentric. I won't fly it with just rear bulk head either.(been there and done it- bad results) Aluminum sheet seems best to me for this. To start with balance and then ridged also. I am not confident of two high speed moving parts that could wear at the attach screw holes. (my experience from the seven screws that held my top cowl to firewall -repaired every couple years.) So I was just looking for bulk heads fore and aft if they were available somewhere. for 10" spinner, for 3 1/4 to 3 1/2" prop hub. made from Aluminum. Thanks, Joe Horton
-----Original Message----- From: n357cj <krnet@list.krnet.org> To: KRnet <KRnet@list.krnet.org> Cc: n357cj <n35...@ptd.net> Date: Wednesday, 22 February 2023 5:28 PM EST Subject: KRnet> spinners Hi Folks, Does anyone have a source suggestion for spinner bulkheads? Apparently they are not available from ACS anymore. I guess I could try aluminum spinning on the lath but I haven't done that since 7th grade (that was sometime in the last century) Thanks, Joe Horton N657JH (reserved)
-- KRnet mailing list KRnet@list.krnet.org https://list.krnet.org/mailman/listinfo/krnet
