Also if you have a TVS200/100/75 in dpits integration, they seemto mess with sync. We power them down till the cabinets are in sync.
Kerry ----- Original Message ----- From: larry <[EMAIL PROTECTED]> To: <[EMAIL PROTECTED]> Sent: Friday, February 22, 2002 2:36 PM Subject: Re: KX-T: KX-TD 1232 dual cabinet troubleshooting > sure a master/slave switch didn't get bumped? > > also, it's easy to break a wire on the tie cable! > > also, if you have modules (esp 185) make sure the > doors are closed! (unless you do our grounded hinge > mod ;-) > > 1. If they are not synced, you should be able to call > a slave ext from a slave ext (test for working slave), > and a master ext can call a master ext(test for > working master). > > 2. be sure 192 cards are firmly connected to cabinet, > and tie cable is firmly connected. > > 3. pull the co lines loose (we use a 25pair > connector(male) with 6 4pr cables (2 rj14 wired > modular plugs). 2 cables(co1-4,co5-8) to base, 1 > cable(co9-12) to 180, on each system. The 25p male > plugs into 25p connectorized block (the co lines). > > you can skip this if you can make damn sure no-one or > thing with pick up ANY CO line. > > 4. Power both systems from the same power strip (or > UPS). Set master & slave power switches "ON". Use > power strip or UPS as THE power switch. Turn UPS on, > wait four minutes, systems should be synced. You can > safely test for sync during power-up by putting > master, port 01 into sys prg mode, then check 116 > sys>1 for a rom id, no id, no sync, id, you have sync. > > 5. reconnect 25 pair co connector > > 6. say blessing for pointed headed pano software > engineer. > > 7. go home > > also, don't use two ups's! > > good luck > > -larry > > > --- Steve Kiene <[EMAIL PROTECTED]> wrote: > > I have dual KX-TD 1232 cabinets connected with a > > system interconnect > > cable. The system was working fine for several weeks > > until we shut it > > down in order to put it on a UPS. Now we > > (apparently) cannot get the > > slave to sync with the master. Extensions on the > > master cannot dial > > extensions on the slave, etc, etc. We've tried > > multiple times to power > > off-power on with no activity for 30 minutes and it > > will not work. > > > > Any hints, tips, etc on how to troubleshoot this > > problem? > > > > Thanks. > > > > Steve > > [EMAIL PROTECTED] > > > __________________________________________________ > Do You Yahoo!? > Yahoo! Sports - Coverage of the 2002 Olympic Games > http://sports.yahoo.com > > _________________________________________________________________ > KX-T Mailing list --- http://kxthelp.com/ > Subscription changes: http://kxthelp.com/mailman/listinfo/kxt _________________________________________________________________ KX-T Mailing list --- http://kxthelp.com/ Subscription changes: http://kxthelp.com/mailman/listinfo/kxt
