Did you install a clock module? > -----Original Message----- > From: [EMAIL PROTECTED] > [mailto:[EMAIL PROTECTED] On Behalf Of Michael Duffy > Sent: Monday, January 21, 2008 5:38 PM > To: 'KXT Mailing list' > Subject: KX-T: PRI Setup on a KXTD1232 > > Hi All > > > > > > I am trying to remember how to setup a full primary rate on a > KXTD1232 V6. > My local telecom provider has provided the PRI with Tellabs > 8110 modem with a RJ45 output to the KXTD1232. I have > connected a patch lead RJ45 with the centre pair of wires > (blue/blue white) going to the lower DDK plug (pins 1 & > 2) and orange/orange white going to the lower pins of the > upper DDK (pins 5 & 6) all on the PRI module KXTD 290. > > > > CRC4 is enabled and have setup the CO keys accordingly. > > > > The KXTD 1232 appears to be synchronising its clocks with the > PRI modem, I can see this through system programming but I > cannot seem to get dial tone of any sort. The telecom > provider says this nothing wrong with there end. > > > > Any ideas. > > > > Regards > > > > Michael > > _________________________________________________________________ > KX-T Mailing list --- http://kxthelp.com/ Subscription > changes: http://kxthelp.com/mailman/listinfo/kxt > >
_________________________________________________________________ KX-T Mailing list --- http://kxthelp.com/ Subscription changes: http://kxthelp.com/mailman/listinfo/kxt
