Michael Typically the transmit pair is on pins 4&5 and the rec pair is 1&2. If the ckt does not work try swapping pairs1&2 with pairs 4&5. If you have a csu plugged into the PRI ckt. all you need is an rj45 patch cable to go from the csu to the pri card on the switch.Set your DID tables to match the digits sent by telco with the destination extensions. You can put the pri in a trk group and dial the code for that group for the outbound portion. Assign a few trunk group keys on all the phones and you are pretty much done. Hope this helps!!! ----- Original Message ----- From: "Michael Duffy" <[EMAIL PROTECTED]> To: "'KXT Mailing list'" <[email protected]> Sent: Monday, January 21, 2008 2:38 PM Subject: KX-T: PRI Setup on a KXTD1232
> Hi All > > > > > > I am trying to remember how to setup a full primary rate on a KXTD1232 V6. > My local telecom provider has provided the PRI with Tellabs 8110 modem > with > a RJ45 output to the KXTD1232. I have connected a patch lead RJ45 with the > centre pair of wires (blue/blue white) going to the lower DDK plug (pins 1 > & > 2) and orange/orange white going to the lower pins of the upper DDK (pins > 5 > & 6) all on the PRI module KXTD 290. > > > > CRC4 is enabled and have setup the CO keys accordingly. > > > > The KXTD 1232 appears to be synchronising its clocks with the PRI modem, I > can see this through system programming but I cannot seem to get dial tone > of any sort. The telecom provider says this nothing wrong with there end. > > > > Any ideas. > > > > Regards > > > > Michael > > _________________________________________________________________ > KX-T Mailing list --- http://kxthelp.com/ > Subscription changes: http://kxthelp.com/mailman/listinfo/kxt > _________________________________________________________________ KX-T Mailing list --- http://kxthelp.com/ Subscription changes: http://kxthelp.com/mailman/listinfo/kxt
