Rick,
If you're starting the system from scratch, i.e. there's nothing in memory
ou want to save at all, then you can do a hard reset which will clear the
entire memory and put you to the factory default settings. This might be a
good idea.
If you haven't done it already, it's like this:
open the cabinet, above the reset button is a "clear/normal" switch.
Put that switch in the "clear" postition.
Now press the reset button.
The red LED on the front of the cabinet will start blinking.
WHILE it is blinking slide the switch back to "normal".
The red LED will go out for a moment then come back on.
Now the system is completely clean of whatever programming was in there
before.
good luck
Charles
----- Original Message -----
From: "Rick McCoy" <[EMAIL PROTECTED]>
To: <[EMAIL PROTECTED]>
Sent: Monday, August 20, 2001 12:17 AM
Subject: KX-T: 1232 Start Up Problems
> Thanks to all for you suggestions, here is where I'm at on my 1232. A
used system with a 7443 display phone on ext 1, a 7420 on ext 2. Two CO
lines hooked up to lines1/2. Did a reset of the cabinet, and when you press
a line button or intercom and 9 you get on the display screen "ACCTN" and
then "CO-Not Assigned"
>
>
>
> *********************************************************
> * To unsubscribe, e-mail [EMAIL PROTECTED] *
> * The KXT-Digest Home Page: http://kxthelp.com/ *
> *********************************************************
>
>
*********************************************************
* To unsubscribe, e-mail [EMAIL PROTECTED] *
* The KXT-Digest Home Page: http://kxthelp.com/ *
*********************************************************
