Aleksandr, the comments below assume your 1232's are the same as ours and
the 2 1232's were twins before you tried to add the 16 cct extn cards
Check on the following if you have not already done so.
CMD 109, slot (whatever) make A1 and A2 for 16 cct cards in both cabinets.
CMD 6--? enable XDP ports.
Remember that the DDK plugs have 2 extns on each plug, starting from hole 1
thru 4 (hole 1 & 2 being a pair) and the first 8 extn numbers on the card
will take the (old) digital extn number plan and the second 8 will take the
analogue extn numbers.
If there is no dail tone on the ports a way to check that the card are
active is test for side tone (battery) on the ports.
Hope this helps
----- Original Message -----
From: "Aleksandr Deulin" <[EMAIL PROTECTED]>
To: <[EMAIL PROTECTED]>
Sent: Friday, September 07, 2001 3:37 PM
Subject: KX-T: Seem`s like ... .
> Hello All!
> Seems like I`m bored so many people on the net, but I`m really in trouble.
> I have 2 KX-TD1232 connected in Master/Slave circut. Cool? But when I`m
connect 2 X 4 CO line expansion (1/1) and 4 X 16SLT expansion(2X2)and enter
right codes in 109 and power down/up my system is working wrong. When CO
lines work - SLT doesn`t work and reverse.
> WHERE IS MY MISTAKE? I`m don`t sleep last night. My boss ready to kill me
8-E
>
> HEEEEEEEEEEEEEEEEEEEEEEEEEEEEEEEEEEEEEEEEEEEEEEEEEEELP!
>
>
>
> *********************************************************
> * To unsubscribe, e-mail [EMAIL PROTECTED] *
> * The KXT-Digest Home Page: http://kxthelp.com/ *
> *********************************************************
>
*********************************************************
* To unsubscribe, e-mail [EMAIL PROTECTED] *
* The KXT-Digest Home Page: http://kxthelp.com/ *
*********************************************************
