First thing would be to really double check the wiring. Bring the phone to
the ksu and connect it right at the punch block with no other wires
connected to that extension. If it works there then there is a wire problem.
If there is a short in the station cable it could cause that effect, such as
if the wire was stapled to the wall and a staple cut into it.
Charles
----- Original Message -----
From: "Dan Maxwell" <[EMAIL PROTECTED]>
To: <[EMAIL PROTECTED]>
Sent: Thursday, September 20, 2001 7:19 PM
Subject: KX-T: KX-TD1232 problem
> I am unable to use extension 109 on my system. When I dial it, the
display from any phone says Not Valid. I've assigned jack 09-1 to extension
109, and jack 09-2 to extension 209. Extension 209 works fine with a single
line telephone. When I plug in a new KX-T7433 phone, or even one of my
other 7433 phones, it sounds like it wants to power up but is dead (no
display, no functionality). It is properly wired from the second pair at
the distribution block and is connected to the yellow/black pair of the
station jack.
>
> Can you help? (Many thanks)
>
>
>
> *********************************************************
> * To unsubscribe, e-mail [EMAIL PROTECTED] *
> * The KXT-Digest Home Page: http://kxthelp.com/ *
> *********************************************************
>
*********************************************************
* To unsubscribe, e-mail [EMAIL PROTECTED] *
* The KXT-Digest Home Page: http://kxthelp.com/ *
*********************************************************
