At 10:09 AM 12/1/2004, you wrote:
When adding in a pair of bobbins at the gimp in point ground lace
(Chantilly, Bucks Point), should I add in a pair of bobbins or 2 single bobbins? Does it matter?

I think it must be better to add in a pair of bobbins, since then there are
no loose ends in the lace. Surely it is bad to have loose ends in the lace.

Hi Julie,

When a thread has gone through 2-3-4 stitches/pins, it should be anchored, not loose. If the thread is started along the gimp a few stitches ahead of where it will strike off on it's own, it should be secure. The only 'loose' part is the part hanging out of the lace. The loose ends of adding single threads are left hanging until the lace is off the pillow, then just clip, one at a time, close to the lace surface. They will not show, and will not come out if they have been anchored .

Of course, tension gently so you don't pull it out of the previous stitches, but then lace tensioning should always be gentle -- just enough to pull the threads to the proper shape without pulling on the previous stitches.

It may be easier to add a pair that is anchored by looping around the gimp, but -- as you said -- winding all those pairs can be tedious.

If there are going to be threads constantly in and out of the lace, there are some ways of dealing with them without winding separate bobbins all the time. One way is to just carry the threads with the gimp until needed again. This works when the space between uses is short. This is used in Floral Bucks.

Another method is to wind your pair full. When it's time to throw out the threads, just lay the pair back to the top of the lace. When needed the next time, pick them up and lay the threads back in the new place and continue working. It's the same as starting loose threads except they have not been cut off. I would have the threads looped around a pin above the working area so you end up with a loop of thread hanging out rather than have the excess threads lying flat to the lace. When the lace is off the pins, just clip both ends of each thread loop neatly.

When this method of re-using the same pair without cutting is followed, and the thread loop is hooked around a pin, there is no danger of pulling the threads out when you tension them. And...... you don't have to wind anything to restart the threads. This may be the method you are looking for.

...the lace off of the pillow, months from now, and give the threads a few weeks
or months to unwork themselves.

If the threads don't pull out when you take the lace off the pins, they should not pull out the next week or month or year, etc. All those stitches around the pins hold the shape of the lace. (And assuming the lace is treated halfway decently and has not been attacked by the resident cats.)


I have to admit that I have done Floral Bucks and not Chantilly, but I think the same methods would work. Any other ideas, fellow Arachneans?

Alice in Oregon -- on a gray day when I have to make a cake for lace meeting potluck tomorrow -- Hallie's Surprise Blackberry Cake -- as ordered by a fellow lacemaker.

-
To unsubscribe send email to [EMAIL PROTECTED] containing the line:
unsubscribe lace [EMAIL PROTECTED] For help, write to
[EMAIL PROTECTED]

Reply via email to