Andrew,
> Does anyone have a set of compiled drivers for the DFE 530TXwhich work with
> the Eigerstein LRP? I have the LRP running using a couple of RTL 10 MHz
> (NE2000 Clone) cards but am trying to upgrade the network to 100MHz. We
> use these cards in our NT boxes almost exclusively so thought to use them
> with the LRP also but without any success so far.
>
> The cards I have have are marked as DFE-530TX REV-B1. They
> also have the number DFE530TX5B1 on one end of the card.
> The 2 main chips on the card are labeled as DL10030A and L80225/B.
As already pointed out the via-rhine driver is the one to use here.
As a warning note, I had loads of trouble with this card and driver. I suspect
the driver as I have no trouble with the same card under NT. The LRP box had
three DFE530TX cards in and would work fine for a while then an interface would
stop with Transmission Timed out errors. I never got to the bottom of it but
swapped the cards for Intel EtherPro 10/100s and not had any problems since.
The markings on my card are as follows :
At end of card 8DFE530TX6B1
Sticker on card REV-A3-1
Chips same as you.
Hope this helps,
--Rich
