Everyone,
I'm having trouble getting the tulip module to load. I'm using Bering1.0_rc3
and have installed both the pci-scan.o and Donald Becker's tulip.o module.
My NICs are Linksys LNE100TX.
lsmod gives me the following...
Module Pages Used by
ip_nat_irc 2384 0 (unused)
ip_nat_ftp 2960 0 (unused)
ip_conntrac_irc 3056 1
ip_conntrac_ftp 3824 1
pci-scan 3048 0 (unused)
ide-pr~1 7492 0
ide-disk 6544 0
ide-mod 50888 0 [ide-pr~1 ide-disk]
My entries in /etc/modules for the two look like this...
pci-scan
tulip
I've also tried...
alias eth0 tulip
alias eth1 tulip
...with no luck.
I'm having no luck finding any documentation that discusses what an entry in
/etc/modules for either of these modules should look like.
Any suggestions?
Thanks,
--
Sak
-----
it's all about strikes now
so here's what's striking me
that some punk could argue some moral abc's
when people are catching what bombers release
i'm on a mission to never agree
--fugazi
-------------------------------------------------------
This sf.net email is sponsored by:ThinkGeek
Welcome to geek heaven.
http://thinkgeek.com/sf
------------------------------------------------------------------------
leaf-user mailing list: [EMAIL PROTECTED]
https://lists.sourceforge.net/lists/listinfo/leaf-user
SR FAQ: http://leaf-project.org/pub/doc/docmanager/docid_1891.html
