What would be a correct default route? Which interface should the route point to, and what should the gateway be?
i tried this, with limited success: ip addr add 192.168.123.2 dev eth0 ip addr add 192.168.123.2 dev eth1 ip route add default scope global via 192.168.123.2 ip link set dev eth0 up ip link set dev eth1 up ./parprouted -d eth0 eth1 I still can't ping things on the far side of the bridge. But the -d option does show parprouted doing what it is supposed to. "Vladimir I." <[EMAIL PROTECTED]> wrote: > Assume you want to bridge eth0 and eth1: > > There is no need to set them in promiscious mode and/or bride > with br0. Just run "parprouted eth0 and eth1". Use the "-d" > switch to see debugging. > > Both interfaces should have an IP address. You can use the same > IP address. Another requirement is existance of correct default > route. > > Also, the routes are installed using "/sbin/ip" command (yep, > I'll fix it sometimes). So you should have /sbin/ip installed on > your system. > > If you still have problems, post the debug log from "-d" and I'll > try to see what's going on. > > Mike Hahn wrote about "Re: [Re: [leaf-user] Leaf wired<->wireless bridging. Is it possible?]": > > > Vladimir, > > > > After compiling and running parprouted for the Bering leaf that I have been > > struggling with, I have found that I really don't understand the proper usage > > of the daemon. > > > > Could you elaborate on the proper configuration of the interfaces for > > parprouted to do its work? Perhaps a sample interfaces definition file. > > > > Also, could you provide some info on any special configuration that is > > required on hosts on either side of the parprouted' bridge? > > > > What I have tried: > > 1. Briding via bridge.o and running parprouted on br0 > > 2. Setting IPs on both interfaces and running parprouted on eth0 and eth1 > > 3. Briding via bridge.o and running parprouted on eth0 and eth1 > > 4. Setting eth0 and eth1 promiscuous and running parprouted on eth0 and eth1 > > > > I've read the manpage, but apparently can't glean the true requirements for > > making it work. > > > > Thanks, > > > > Mike > > -- > Best Regards, > Vladimir > Systems Engineer (RHCE) ------------------------------------------------------- This sf.net email is sponsored by:ThinkGeek Welcome to geek heaven. http://thinkgeek.com/sf ------------------------------------------------------------------------ leaf-user mailing list: [EMAIL PROTECTED] https://lists.sourceforge.net/lists/listinfo/leaf-user SR FAQ: http://leaf-project.org/pub/doc/docmanager/docid_1891.html
