At 05:45 PM 1/3/03 -0600, Jeremy A Tourville wrote:
Following up on Tom's reply ... if he's right, then you need to check on your interfaces with "ip addr show", to see if both eth0 and eth1 have come up. This assumes, of course, that you have a regular 2-NIC setup; if, for example, you are instead using a dialup external connection, you have the interfaces specified incorrectly (they will be either ppp0 and eth0 for true dialup, or, usually, ppp0 and eth1 for PPPoE pseudo-dialup).As I set up my Firewall/Router everything seems to be ok except for two error messages: "Cannot set route filtering on eth0" and "eth1 must be up before shorewall starts" Can anyone give me ome clues whare to get started on this? Your help is greatly appreciated. Thanks!
The SR FAQ, referenced below, will help you get started with more systematic troubleshooting.
--
-------------------------------------------"Never tell me the odds!"--------
Ray Olszewski -- Han Solo
Palo Alto, California, USA [EMAIL PROTECTED]
-------------------------------------------------------------------------------
-------------------------------------------------------
This sf.net email is sponsored by:ThinkGeek
Welcome to geek heaven.
http://thinkgeek.com/sf
------------------------------------------------------------------------
leaf-user mailing list: [EMAIL PROTECTED]
https://lists.sourceforge.net/lists/listinfo/leaf-user
SR FAQ: http://leaf-project.org/pub/doc/docmanager/docid_1891.html
