Hello. I'm migrating from Bering 1.0 to Bering uClibc 2.2.3. The reson for that is that ComHem (Swedish Cable modem ISP) is switching from NeMo modems to WebStar modems and the 1.0 doesn't work. Somwhere I read that pump is a problem, so I thought I change to something newer, Bering uClibC 2.2.3.
I have a cable modem and want the eth0 to get its configuration via DHCP. I have an internal network, eth1, with WinXP computers which I want to receive their configuration via DHCP. I have read the manuals and setup everything so it should work, but the WinXp computers can not get any DHCP configuration. How shall I configure the firewall/gateway and internal LAN PCs if for example I want the gateway, internally, to be known as portellen.islay 192.168.1.1 or 192.168.1.254 and the internal computers as e.g. ardbeg.islay on network 192.168.1.X? You can asume I got the original setting from the disk image. The only changes are so that I only can connect through a serial line (COM1). Took a while before I realised I hade to boot on another computer to change the settings so I could boot on a computer without a graphical display. I know I should send printouts of my settings but I'm a bit frustrated after spending 20 hours and getting nowhere... It shouldn't be needed to read five different manuals to get nothing to work. /patrick ------------------------------------------------------- This SF.Net email is sponsored by: Power Architecture Resource Center: Free content, downloads, discussions, and more. http://solutions.newsforge.com/ibmarch.tmpl ------------------------------------------------------------------------ leaf-user mailing list: [email protected] https://lists.sourceforge.net/lists/listinfo/leaf-user Support Request -- http://leaf-project.org/
