Hello Jeremy,
Attached you will find the drivers from today's snapshot. I hope they work!
Eric
Well, I tried the new drivers you compiled with no luck. Is my card still
not supported by the new code drop? I have a MIMO card. It is a D Link
DWL-G520M. It has the AR5513 processor/chipset. Here is some diagnostic
output for everyone. I have snipped some output to only include relevant
info.
firewall# cat /proc/pci
PCI devices found:
Bus 0, device 11, function 0:
Class 0200: PCI device 168c:0020 (rev 1).
IRQ 9.
Master Capable. Latency=80. Min Gnt=10.Max Lat=28.
Non-prefetchable 32 bit memory at 0xfcfe0000 [0xfcffffff].
firewall# dmesg
wlan: 0.8.4.2 (Atheros/multi-bss)
wlan: mac acl policy registered
ath_hal: 0.9.15.1 (AR5210, AR5211, AR5212, RF5111, RF5112, RF2413, RF5413)
ath_rate_onoe: 1.0
ath_pci: 0.9.4.5 (Atheros/multi-bss)
firewall# more modules
# /etc/modules: kernel modules to load at boot time.
#
# Wireless AP
wlan
wlan_acl
wlan_tkip
wlan_xauth
ath_hal
ath_rate_onoe
ath_pci
firewall# lsmod
Module Size Used by Tainted: P
ath_pci 56820 0 (unused)
ath_rate_onoe 2900 0 [ath_pci]
ath_hal 179184 0 [ath_pci]
wlan_xauth 216 0 (unused)
wlan_tkip 8368 0 (unused)
wlan_acl 1784 0 (unused)
wlan 116530 0 [ath_pci ath_rate_onoe wlan_xauth wlan_tkip
wlan_acl]
softdog 1360 1
ipt_state 272 17
ipt_helper 400 0 (unused)
ipt_conntrack 692 0
ipt_REDIRECT 480 0 (unused)
ipt_MASQUERADE 1024 2
ip_nat_irc 1704 0 (unused)
ip_nat_ftp 2152 0 (unused)
iptable_nat 14332 3 [ipt_REDIRECT ipt_MASQUERADE ip_nat_irc
ip_nat_ftp]
ip_conntrack_irc 2484 1
ip_conntrack_ftp 3132 1
ip_conntrack 16516 2 [ipt_state ipt_helper ipt_conntrack
ipt_REDIRECT ipt_MASQUERADE ip_nat_irc ip_nat_ftp iptable_nat
ip_conntrack_irc ip_conntrack_ftp]
3c59x 23768 2
3c515 11052 1
isofs 15732 0 (unused)
ide-detect 132 0 (unused)
ide-cd 26748 0
ide-disk 11308 0
ide-core 80476 0 [ide-detect ide-cd ide-disk]
cdrom 25344 0 [ide-cd]
firewall# ip address show
1: lo: <LOOPBACK,UP> mtu 16436 qdisc noqueue
link/loopback 00:00:00:00:00:00 brd 00:00:00:00:00:00
inet 127.0.0.1/8 scope host lo
2: dummy0: <BROADCAST,NOARP> mtu 1500 qdisc noop
link/ether 00:00:00:00:00:00 brd ff:ff:ff:ff:ff:ff
3: eth0: <BROADCAST,MULTICAST,UP> mtu 1500 qdisc pfifo_fast qlen 1000
link/ether 00:10:4b:6e:ef:9a brd ff:ff:ff:ff:ff:ff
inet 70.224.209.172/24 brd 70.224.209.255 scope global eth0
4: eth1: <BROADCAST,MULTICAST,UP> mtu 1500 qdisc pfifo_fast qlen 1000
link/ether 00:a0:24:37:d4:c0 brd ff:ff:ff:ff:ff:ff
inet 192.168.1.254/24 brd 192.168.1.255 scope global eth1
5: eth2: <BROADCAST,MULTICAST,UP> mtu 1500 qdisc pfifo_fast qlen 1000
link/ether 00:a0:24:75:b2:50 brd ff:ff:ff:ff:ff:ff
inet 192.168.2.100/24 brd 192.168.2.255 scope global eth2
# /etc/network/interfaces -- configuration file for LEAF network
# Step 7 (optional): configure wireless AP (Madwifi)
auto ath0
iface ath0 inet static
address 192.168.3.1
netmask 255.255.255.0
broadcast 192.168.3.255
wireless-mode master
wireless rate 54M
wireless-essid default
up /sbin/iwpriv/ ath0 mode 3
Thanks all in advance for your help!
Jeremy
-------------------------------------------------------
This SF.Net email is sponsored by the JBoss Inc.
Get Certified Today * Register for a JBoss Training Course
Free Certification Exam for All Training Attendees Through End of 2005
Visit http://www.jboss.com/services/certification for more information
------------------------------------------------------------------------
leaf-user mailing list: [email protected]
https://lists.sourceforge.net/lists/listinfo/leaf-user
Support Request -- http://leaf-project.org/
