Hi Eric, >Ok, > >So I have my leaf box up an running with eth0 working correctly. I have >gotten the wireless card up an running with the madwifi drivers and all >of the tools seem to work. My next step is to actually convert this >over to running WPA2 and bridged. Are there any instructions for this >anywhere? I have found bits and pieces of them all over the place. > What you need is the hostapd.lrp and the bridge.lrp package. There is no Bering-uClibc documentation for this setup, but the madwifi wiki should be enough to get it running: http://madwifi.org/wiki/UserDocs http://madwifi.org/wiki/UserDocs/HostAP http://madwifi.org/wiki/UserDocs/WPA_PSK_on_Both_Ends
>As a follow up question I currently have 1 EMP-8602 (400mw a/b/g) >radios. I have noticed that iwlist txpower only lists up to about >50mW. Anyone know why this is? Maybe because of: http://madwifi.org/wiki/UserDocs/CountryCode > Also is it possible to run an access >point in both 802.11a-land and 802.11b-land at the same time with the >one radio (I would assume not)? > Not sure, but the answer should be available in the wiki. It is possible to create multiple interfaces with madwifi (VAP) with one radio for example, so maybe it could be done. >-Eric > Eric ------------------------------------------------------------------------- Take Surveys. Earn Cash. Influence the Future of IT Join SourceForge.net's Techsay panel and you'll get the chance to share your opinions on IT & business topics through brief surveys - and earn cash http://www.techsay.com/default.php?page=join.php&p=sourceforge&CID=DEVDEV ------------------------------------------------------------------------ leaf-user mailing list: [email protected] https://lists.sourceforge.net/lists/listinfo/leaf-user Support Request -- http://leaf-project.org/
