OSPF routing should work by default.
Make sure that OSPF key is the same on both nodes, and check that routing tables are correct by doing "ip route". Note that if OSPF is working you will have routes with "proto zebra" in the list.
Ray Gwinn wrote:
Vladimir, I have one wisp-disp node up and running fine. This node has an internet feed via eth0. All hardware is Soekris 4521.
I have now up a second node. This second node is wireless only. That is, the second node's internet feed is one of the radios connected to a small beam pointing at the first (working) node. User's can associate with the second node, but there seems to be a routing problem.
My question is, should the default wisp-disp zebra/ospf configs work on both nodes? If not, can you provide any clues about configuring zebra/ospf for the two nodes?
Ray
------------------------------------------------------- This SF.Net email is sponsored by the new InstallShield X.From Windows to Linux, servers to mobile, InstallShield X is theone installation-authoring solution that does it all. Learn more and evaluate today! http://www.installshield.com/Dev2Dev/0504 _______________________________________________ leaf-wisp-dist mailing list [EMAIL PROTECTED] https://lists.sourceforge.net/lists/listinfo/leaf-wisp-dist
-- Best Regards, Vladimir Ivashchenko ThunderWorx - www.thunderworx.com Senior Systems Designer/Engineer
------------------------------------------------------- This SF.Net email is sponsored by the new InstallShield X.
From Windows to Linux, servers to mobile, InstallShield X is the
one installation-authoring solution that does it all. Learn more and evaluate today! http://www.installshield.com/Dev2Dev/0504 _______________________________________________ leaf-wisp-dist mailing list [EMAIL PROTECTED] https://lists.sourceforge.net/lists/listinfo/leaf-wisp-dist
