anyone can help? its already working.

Just need guidance about best place to put the configuration for it
and register the callback...


On Tue, Oct 25, 2016 at 9:13 PM, Juan Rios <> wrote:
> Hello again,
>     I have been working on adding support for this router with the
> help of SCApi and we got it to the point that Ethernet ports works,
> leds and buttons works and wifi card 0xa8d6 43222 works.
> The wifi card don't have sprom and I had to write a patch to add
> fallback sprom support for this card.
> The sprom is not located in flash or at least I could not find it. I
> used the logs from original firmware and information from broadcom
> architecture to make it and put the interesting values and it works.
> To supply sprom buffer I need the mac address of the interface. I want
> to use the Ethernet mac address + 2. The Ethernet mac address is
> stored in mtd at certain offset.
> Where should be the registration of the sprom fallback function?.
> Right now I did it in the b43_pci_ssb_bridge_init function from the
> drivers/ssb/pci_b43_bridge.c file.
> Also It is needed a way to specify the mtd partition where the mac
> address is stored, the offset and the increment needed to the mac
> address. Where and how should this be put?
> Right now there is only three lantiq routers with broadcom wifi card
> that I know of and may be in the same situation.
> Regards
> Juan Rios

Lede-dev mailing list

Reply via email to