On Feb 4, 2013, at 4:33 PM, John Peterson <jwpeter...@gmail.com> wrote:
> We have one that is enabled if you build libmesh with ParallelMesh support, > and it appears to be "green" right now. > > I admit I have not been building with ParallelMesh enabled during the whole > automake transition, however ;-P That helps actually - couldn't remember if parallel mesh was required to successfully read a nemesis mesh. I just did 'mpirun -np 4 meshtool-dbg -i cylinder.n' and it freaked with a serial mesh, am rebuilding with parallel mesh right now… …parallel mesh reads properly, writes nemesis without error, but cannot read the written file. I'll see about some more intelligent error checking, in case I ignore this section of code again for 5 years… I assume your test just reads a mesh and runs with it? -Ben ------------------------------------------------------------------------------ Free Next-Gen Firewall Hardware Offer Buy your Sophos next-gen firewall before the end March 2013 and get the hardware for free! Learn more. http://p.sf.net/sfu/sophos-d2d-feb _______________________________________________ Libmesh-devel mailing list Libmesh-devel@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/libmesh-devel
