Sent from my iPhone On Feb 4, 2013, at 5:45 PM, "Kirk, Benjamin (JSC-EG311)" <benjamin.kir...@nasa.gov> wrote:
> > On Feb 4, 2013, at 4:33 PM, John Peterson <jwpeter...@gmail.com> wrote: > >> We have one that is enabled if you build libmesh with ParallelMesh support, >> and it appears to be "green" right now. >> >> I admit I have not been building with ParallelMesh enabled during the whole >> automake transition, however ;-P > > That helps actually - couldn't remember if parallel mesh was required to > successfully read a nemesis mesh. > > I just did 'mpirun -np 4 meshtool-dbg -i cylinder.n' and it freaked with a > serial mesh, am rebuilding with parallel mesh right now… > > …parallel mesh reads properly, writes nemesis without error, but cannot read > the written file. > > I'll see about some more intelligent error checking, in case I ignore this > section of code again for 5 years… > > I assume your test just reads a mesh and runs with it? > Well I'm not in the office but I believe our test reads, runs and also writes with Nemesis format. Can double check tomorrow. Cody > -Ben > > > > ------------------------------------------------------------------------------ > Free Next-Gen Firewall Hardware Offer > Buy your Sophos next-gen firewall before the end March 2013 > and get the hardware for free! Learn more. > http://p.sf.net/sfu/sophos-d2d-feb > _______________________________________________ > Libmesh-devel mailing list > Libmesh-devel@lists.sourceforge.net > https://lists.sourceforge.net/lists/listinfo/libmesh-devel ------------------------------------------------------------------------------ Free Next-Gen Firewall Hardware Offer Buy your Sophos next-gen firewall before the end March 2013 and get the hardware for free! Learn more. http://p.sf.net/sfu/sophos-d2d-feb _______________________________________________ Libmesh-devel mailing list Libmesh-devel@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/libmesh-devel
