Date: Fri, 6 Sep 2002 01:28:10 +0100
From: "Alex Slater" <[EMAIL PROTECTED]>
Subject: 70CT + new 20g HD + linux strategy?

Hi all,

I'm due to pick up a 70CT tomorrow and am looking for some advice on some OS
installs and a HD upgrade.

I've got  9.5mm 20gig drive sitting here, so my plan is to install the 20g
drive and run win98 and some flavour of linux..

After trawling through the mailing list archives the "install linux" +
"drives over 8gig"  combination seems to combine the worst of both worlds!
It's very hard to build up a clear picture from the archives as there is so
much information there.

If anyone has any tips before I start I'd appreciate it.

Hardware wise I'll have :
 The 70CT, 2 x  PCMCIA NICs (3com and a NE2000 clone), an enhanced port
replicator, a desktop PC running win2k (with NIC), 2.5" to 3.5" HD
converter, new 20g drive.

The plan:
 Stick new HD in Lib, boot off a Win98 boot disk format the visible drive
into two FAT32 partitions.

I'm assuming here that the 20g drive will just show up as a 8.4g drive (due
to the BIOS limitations). Will I have to leave space at the end for the
hibernation dump or will that be done considering I'm using the Lib for the
format?

Stick the drive in the desktop PC, copy over win98 install set.

Put drive back in Lib, install Win98. Set up networking to desktop.

Now what I'm hoping is that from here I can do a linux install into the
remaining 11 or so gig on the drive (due to Linux ignoring the BIOS set-up
for HDs??) ?

Any chance I'll be able to do this by putting the Lib in the port
replicator,  plugging in a network card and the floppy drive and doing some
sort of network install  after booting from a linux floppy (back to my
Desktop) of some flavour of Linux?

Any advice would be a appreciated.

Cheers,
 Alex.




**************************************************************
http://libretto.basiclink.com - Libretto mailing list
http://www.silverace.com/libretto/ - Archives

                 -------TO UNSUBSCRIBE-------
Reply to any of the list messages. The reply mail should be
addressed to: [EMAIL PROTECTED] - Then replace any text
on the message's subject line: cmd:unsubscribe
              --------TO UNSUBSCRIBE DIGEST------
Do above but with this on subject line: cmd:unsubscribe digest
**************************************************************


Reply via email to