Date: Mon, 31 May 2004 16:26:13 -0700 From: Mark Srebnik <[EMAIL PROTECTED]> Subject: Re: EZ-Drive installer - WORKED!
That did it Matt! PartitionMagic reports partitions are fine now and DriveImage worked great! Thanks!!! Mark on 5/31/04 1:23 AM, Matt Hanson at [EMAIL PROTECTED] wrote: >> From: Mark Srebnik <[EMAIL PROTECTED]> >> >> Could you please send it?? > > Here you go Mark. Unzip and run the .eze and run it to create a boot floppy > that will install EZ-Drive. You can follow my instructions from my last > post... but here's a bit more about some menus I wasn't clear on: > > EZ-BIOS Setup: > --------------------------------- > > * Select 2nd menu option > 'Advanced Options' (1st is 'Fully Automatic > Install) > * From the 'Advanced Options' select "EZ-Bios Setup" > * At message: 'EZ-BIOS is not installed. Install now?', choose 'Yes' and > exit all screens to reboot. > > From then on, you must hit 'CTRL' when prompted by EZ-Drive at boot in order > to boot from a floppy. Leave the FD out of drive, hit CTRL, insert FD, hit > an y key. > > From what you've written, my bet is that your problems with PM8 and > DriveImage will probably disappear. If for some reason it's a no-go... try > Symantec support via email (very slow and frustrating), or try the > Compuserve Windows and/or PC Hardware forums > > For EZ-BIOS Uninstall: > --------------------------------- > > * 2nd menu option > 'Advanced Options' (1st is 'Fully Automatic Install) > * 'Advanced Options' select "EZ-Bios Setup" > * Select "Controlled by EZ-BIOS" and hit ENTER > * Select 'Exit and save changes' and it ENTER > . Will exit to "EZ-Bios Setup" > * Re-enter "EZ-Bios Setup" menu. > * Select "Uninstall EZ-BIOS > * Exit program > > Get back to me with a post to the list, this going right to you. > > Good luck. > > Matt > > _________________________________________________________________ > FREE pop-up blocking with the new MSN Toolbar � get it now! > http://toolbar.msn.click-url.com/go/onm00200415ave/direct/01/ > ************************************************************** http://libretto.basiclink.com - Libretto mailing list http://www.silverace.com/libretto/ - Archives -------TO UNSUBSCRIBE------- Reply to any of the list messages. The reply mail should be addressed to: [EMAIL PROTECTED] - Then replace any text on the message's subject line: cmd:unsubscribe --------TO UNSUBSCRIBE DIGEST------ Do above but with this on subject line: cmd:unsubscribe digest **************************************************************
