[ dropping libtool@ ] Hi Peter,
thanks for working on this! * Peter Rosin wrote on Tue, Jan 04, 2011 at 05:44:58PM CET: > Subject: [PATCH] Convert ranlib argument to toolchain format. > --- a/libltdl/config/ltmain.m4sh > +++ b/libltdl/config/ltmain.m4sh > @@ -2412,6 +2412,8 @@ func_mode_install () > > # Set up the ranlib parameters. > oldlib="$destdir/$name" > + func_to_tool_file "$oldlib" func_convert_file_msys_to_w32 > + tool_oldlib=$func_to_tool_file_result Why does the $old_striplib command a few lines below this one not need to use $tool_oldlib? Dan, can you try 'make install-strip'? > func_show_eval "$install_prog \$file \$oldlib" 'exit $?' > > @@ -8370,6 +8372,8 @@ EOF > esac > done > fi > + func_to_tool_file "$oldlib" func_convert_file_msys_to_w32 > + tool_oldlib=$func_to_tool_file_result > eval cmds=\"$old_archive_cmds\" > > func_len " $cmds" [...] * Peter Rosin wrote on Wed, Jan 05, 2011 at 11:06:09AM CET: > Den 2011-01-05 05:30 skrev Dan McMahill: > > On 1/4/2011 11:44 AM, Peter Rosin wrote: > >> Ok, I found a couple of minutes to look at this. Can you check if this > >> patch helps? > >> > >> (It still needs a ChangeLog etc...) The patch is OK with me if you fix the missing bits, and address the above. > Before I tie up the lose ends with this patch, I wonder if Ralf (or someone > else) could tell me if I should also fix the other assignments of > old_archive_cmds -- such as in the below snippet -- or is that completely > irrelevant? I wouldn't change them without being sure that the changes are necessary. Thanks, Ralf