Re: Director & lingo & xtras on embedded windows

[John Mathis]

I believe the problem is the limited memory -- I use 512 MB Compact Flash, 
with 256 Mb ram.  No doubt I could improve memory usage, but a daily restart 
is not a bad alternative.  Of course, more memory should also help.

I'm using an XPE image that takes around 400Mb, leaving 100MB for my app & 
swap space...my app is around 10-15 MB (all dcr & cct).

I expect I could optimize the XPE image further, but that's what I have now.
----- Original Message ----- 
From: "Tim Welford" <[EMAIL PROTECTED]>
To: "Lingo programming discussion list" <lingo-l@lists.fcgnetworks.net>
Sent: Friday, March 18, 2005 9:44 AM
Subject: RE: <lingo-l> Director & lingo & xtras on embedded windows


Excellent, Thanks a lot John, do you know in what respect you are having
problems with the virtual memory, is this cause you are booting from a
disk and there is no hard drive, or because the XP image you have does
not include the virtual memory options etc or something else.  And could
this be alleviated by having just a massive amount of good quality RAM
in?
Thanks very much
Tim
-----Original Message-----
From: [EMAIL PROTECTED]
[mailto:[EMAIL PROTECTED] On Behalf Of John Mathis
Sent: 18 March 2005 13:27
To: Lingo programming discussion list
Subject: Re: <lingo-l> Director & lingo & xtras on embedded windows
Does anybody have any experience with using director (any version)
projectors on Windows CE or Windows XP Embedded platforms.

I have about 35 units deployed with Windows XP Embedded.  I was
surprised at
how well it works. The main problem I'm having is related to virtual
memory.
I addressed this by doing a daily restart.
Windows CE will not run a projector.
John Mathis
Inplicity
[To remove yourself from this list, or to change to digest mode, go to
http://www.penworks.com/lingo-l.cgi  To post messages to the list, email
lingo-l@penworks.com  (Problems, email [EMAIL PROTECTED]).
Lingo-L is for learning and helping with programming Lingo.  Thanks!]

[To remove yourself from this list, or to change to digest mode, go to 
http://www.penworks.com/lingo-l.cgi  To post messages to the list, email 
lingo-l@penworks.com  (Problems, email [EMAIL PROTECTED]). Lingo-L 
is for learning and helping with programming Lingo.  Thanks!] 
[To remove yourself from this list, or to change to digest mode, go to http://www.penworks.com/lingo-l.cgi  To post messages to the list, email lingo-l@penworks.com  (Problems, email [EMAIL PROTECTED]). Lingo-L is for learning and helping with programming Lingo.  Thanks!]