Just set "the scriptExecutionStyle=9" somewhere before the legacy code.
If you are likely to start using any of the new lingo for MX04, just set
"the scriptExecutionStyle=10" before the new code.
-Mike
Matthew Kaplan wrote:
OK so I'm finally moving up to Director MX 2004.
I'm updating a huge project which was released three years ago and was
authored in Director 8.5. The project is choking on old MIAW code.
Terms like "windowType" and "titleVisible".
I see there is new code in MX04 which accomplishes all I could wish
for and more, as regards MIAWs. But is it true that the old code is
broken and now needs to be replaced? I'm trying to minimize my changes
to the actual code and this will involve lots of new lines. Or am I
missing something.
The project is cross platform. So far I'm only working on OSX panther.
Thanks for any guidance here.
Matthew
[To remove yourself from this list, or to change to digest mode, go to
http://www.penworks.com/lingo-l.cgi To post messages to the list, email
[email protected] (Problems, email [EMAIL PROTECTED]). Lingo-L is for
learning and helping with programming Lingo. Thanks!]
