Except that doesn't actually work for MIAWs or Timeout objects and
probably some other objects, too.
roymeo
At 11:42 AM 8/12/2005, you wrote:
Just set "the scriptExecutionStyle=9" somewhere before the legacy code.
If you are likely to start using any of the new lingo for MX04, just
set "the scriptExecutionStyle=10" before the new code.
-Mike
Matthew Kaplan wrote:
OK so I'm finally moving up to Director MX 2004.
I'm updating a huge project which was released three years ago and
was authored in Director 8.5. The project is choking on old MIAW
code. Terms like "windowType" and "titleVisible".
I see there is new code in MX04 which accomplishes all I could wish
for and more, as regards MIAWs. But is it true that the old code is
broken and now needs to be replaced? I'm trying to minimize my
changes to the actual code and this will involve lots of new lines.
Or am I missing something.
The project is cross platform. So far I'm only working on OSX panther.
Thanks for any guidance here.
Matthew
[To remove yourself from this list, or to change to digest mode, go
to http://www.penworks.com/lingo-l.cgi To post messages to the
list, email [email protected] (Problems, email
[EMAIL PROTECTED]). Lingo-L is for learning and helping with
programming Lingo. Thanks!]
-----------
Roy Crisman
Macromedia Director Programmer, Lingo Guru, Multimedia Producer
150 Laidley St #1
San Francisco, CA 94131-2754
(415)568-2900x39
(415)695-1972 home
(585)615-2873 cell
http://www.brokenoffcarantenna.com/
roymeo(AT)brokenoffcarantenna.com
[To remove yourself from this list, or to change to digest mode, go to
http://www.penworks.com/lingo-l.cgi To post messages to the list, email
[email protected] (Problems, email [EMAIL PROTECTED]). Lingo-L is for
learning and helping with programming Lingo. Thanks!]
