Hello! I need help again. I'm having trouble with the stub projectors for a while now. I think I'm doing something wrong because I've done a couple of projects using this technique to make the projector start faster and I haven't accomplished this.
What I'm doing is to set up a movie following the instructions of Macromedia for a stub projector but I don't make it work faster. It takes more than 10 seconds to start. Some users with the MX version tried to open the disk again having two or three versions of the same application running because this slow start up process. My first movie it doesn't have Xtras (use them externally) but I register the PrintOMatic MX Xtra and the V12 on that movie. Will this be the problem? According with the PrintOMatic documentation I have to put the Xtra on the first movie of the projector to be properly registered. Is this correct use of the registration process or I'm doing something wrong. Thank you in advance. Hermann Brandi [To remove yourself from this list, or to change to digest mode, go to http://www.penworks.com/lingo-l.cgi To post messages to the list, email [EMAIL PROTECTED] (Problems, email [EMAIL PROTECTED]). Lingo-L is for learning and helping with programming Lingo. Thanks!]
