I'm ready about the new imaging lingo and just tooling around a tad....I
know that depth can be tested but not set -- however, is there a way to
change the depth of a member some other way?
My guess is something along the lines of creating an image at a lower
depth and then copyPixels to that one from the higher depth.......er......
--------------------[ http://www.grimmWERKS.com ]------------------
[ graphic design -|- sound design -|- shockwave -|- lingo -|- cdrom ]
[To remove yourself from this list, or to change to digest mode, go to
http://www.penworks.com/LUJ/lingo-l.cgi To post messages to the list,
email [EMAIL PROTECTED] (Problems, email [EMAIL PROTECTED])
Lingo-L is for learning and helping with programming Lingo. Thanks!]
