You were faster than me this time TR Schussler, but the next time
I'll draw even sooner. Anyway I owe most of my imaging Lingo skills
to you and Trevimedia's D8 Advanced seminar in Stockholm...
-Andreas
>At 2:33 AM -0400 9/6/00, grimmwerks wrote:
>>I'm ready about the new imaging lingo and just tooling around a tad....I
>>know that depth can be tested but not set -- however, is there a way to
>>change the depth of a member some other way?
>>
>>My guess is something along the lines of creating an image at a lower
>>depth and then copyPixels to that one from the higher depth.......er......
>
>srcImage = (member "bitmapExample").image
>newImageBuffer = image(srcImage.width, srcImage.height, 8)
>newImageBuffer.copyPixels(srcImage, srcImage.rect, srcImage.rect, [#dither
>: TRUE])
>(member "bitmapExample").image = newImageBuffer
>
>(This example requires that your bitmap castmember is already 16 or higher
>bit depth)
>
>Regards,
>
>Terry
>
>--
>
>...---===| Terry R. Schussler |===---...
>...---===| DIA Chief Investigator |===---...
>
>on visitWebsite yourSelection
> coolSites = [ \
> #greatSeminars : "http://www.macromediaSEMINARS.com/", \
> #directorIntelligenceAgency: "http://www.director8.com", \
> #freeBehaviors : "http://www.behaviors.com/"]
> gotoNetPage coolSites[yourSelection]
>end visitWebsite
>
>
>[To remove yourself from this list, or to change to digest mode, go to
>http://www.penworks.com/LUJ/lingo-l.cgi To post messages to the list,
>email [EMAIL PROTECTED] (Problems, email [EMAIL PROTECTED])
>Lingo-L is for learning and helping with programming Lingo. Thanks!]
[To remove yourself from this list, or to change to digest mode, go to
http://www.penworks.com/LUJ/lingo-l.cgi To post messages to the list,
email [EMAIL PROTECTED] (Problems, email [EMAIL PROTECTED])
Lingo-L is for learning and helping with programming Lingo. Thanks!]
