At 10:02 AM -0500 9/21/2000, Rob Madgwick wrote:
>I have created my project on dir8 Mac - created a projector no problem -
>then opened up my project on dir8 Win and created a win projector, but on
>running it I get the error message:
>
>Unable to load movie playlist. Does the .INI file exist. It must contain a
>section "[Movies]" with an entry 'Movie01=Pathname.dir'
>
>though it runs fine from within dir8
>
>can anyone point me in the right direction
Don't know if this is a direction - but I have had the same issue
come up when creating a projector for the PC on a Mac running VPC.
With the projector in the Mac/PC shared folder, I would get this
error message. Moving the projector to the C drive resolved it. I
thought this was a VPC issue - but you might try moving it to your
primary drive (if it isn't there already).
Not a solution - but if it works there, then at least you may have
isolated a bug.
(fwiw - trying to provide such an ini file had no effect)
/r
--
Roy Pardi
[To remove yourself from this list, or to change to digest mode, go to
http://www.penworks.com/LUJ/lingo-l.cgi To post messages to the list,
email [EMAIL PROTECTED] (Problems, email [EMAIL PROTECTED])
Lingo-L is for learning and helping with programming Lingo. Thanks!]
