The problem is that Shockwave doesn't support alpha channels. You have to
use 24 bit images.
Charlie Fiskeaux II
The Creative Group
www.cre8tivegroup.com
859/858-9054 x29
cell: 859/312-3883
----- Original Message -----
From: "Fabricio G. Bissoli" <[EMAIL PROTECTED]>
To: <[EMAIL PROTECTED]>
Sent: Friday, February 09, 2001 11:17 AM
Subject: <lingo-l> image with alpha channel and "glow" effect
Sorry for the offtopic, it is a Director question (not Lingo):
I create a image (elipse) in 32 bits (alpha channel) and a white glow
effect. Ok, all right, but when I create a Shockwave movie this image is
showed in a wrong position. Strange... in movie mode and projector mode it
works fine... the problem is only in the Shockwave movie.
The problem is from the glow effect. If I remove the glow the problem is
out.
Any idea?
Thanks
Fabricio Guedes Bissoli
Phasis Multimidia
55 32 3218-5343
55 32 9103-7978
[To remove yourself from this list, or to change to digest mode, go to
http://www.penworks.com/LUJ/lingo-l.cgi To post messages to the list,
email [EMAIL PROTECTED] (Problems, email [EMAIL PROTECTED])
Lingo-L is for learning and helping with programming Lingo. Thanks!]
[To remove yourself from this list, or to change to digest mode, go to
http://www.penworks.com/LUJ/lingo-l.cgi To post messages to the list,
email [EMAIL PROTECTED] (Problems, email [EMAIL PROTECTED])
Lingo-L is for learning and helping with programming Lingo. Thanks!]
