That's hard to answer without seeing what code you DO have.
Try putting an alert box before the "go to the frame" just to verify that
it actually hits that script. Otherwise it may not even be making it to
that script. Usually it's not so much that the script is ignored but that
you don't really get there.
If it truly does seem to be ignored, try doing a recompile on the script.
Otherwise check syntax around it and make sure you don't really have it
embedded in some other handler or something silly like that.
But start with the alert box.
- Tab
At 07:12 AM 2/23/01 -0800, Abdou Diaw wrote:
>Hi,
>Using D8 I have a movie that works fine in the authoring environment.
>At the last frame I have a "go to the frame" script for the movie to wait
>for a user action. But when I create a projector, the projector ignores the
>go-to-the-frame script and exits unexpectedly.
>I tried the "pause" command but it did not help.
>Thanks for any help.
>
>
>[To remove yourself from this list, or to change to digest mode, go to
>http://www.penworks.com/LUJ/lingo-l.cgi To post messages to the list,
>email [EMAIL PROTECTED] (Problems, email [EMAIL PROTECTED])
>Lingo-L is for learning and helping with programming Lingo. Thanks!]
[To remove yourself from this list, or to change to digest mode, go to
http://www.penworks.com/LUJ/lingo-l.cgi To post messages to the list,
email [EMAIL PROTECTED] (Problems, email [EMAIL PROTECTED])
Lingo-L is for learning and helping with programming Lingo. Thanks!]
