Hello I am trying to set the position of my stage to the center of the screen on both mac and pc's, with both 800x600 and 1024X768 resolution. To do that I tried to center my stage on both the mac and pc version of my project. When I check the mac projector on both resolutions, it appears centered in both cases. When I check it on a pc, it doesen't work : if I centered the screen in 1024x768, then when I test the projector in 800x600 it appears eaten by the lower right part of the screen. If I center the stage while in 800x600, then when I test the projector in 1024x768, the stage appears in the higher left part of the screen. It is not eaten up by the screen, so that is ok, but it is not centered. Does anyone know anything about this issue? I'm sure there must be some lingo to avoid this problem, but am I doing anything wrong in the first place? Thanks in advance -- Alex Czetwertynski Disciple Films Paris www.disciplefilms.com [To remove yourself from this list, or to change to digest mode, go to http://www.penworks.com/LUJ/lingo-l.cgi To post messages to the list, email [EMAIL PROTECTED] (Problems, email [EMAIL PROTECTED]) Lingo-L is for learning and helping with programming Lingo. Thanks!]
