There are a few things you can look at... 1) The center stage option when you make the projector should be checked. 2) The "make all movies like first movie" or whatever it is should be checked otherwise: 3) The movie itself can have a setting. Look at modify | movie | properties | options, if I recall correctly (maybe not as far as options) and somewhere in there is something for setting both the size of the stage and the POSITION of the stage. 4) Worse comes to worse, there is a Lingo property 'the centerstage' which you can use like so: set the centerStage to TRUE - Tab At 11:11 AM 3/27/01 +0200, Disciple1 wrote: >Hello >I am trying to set the position of my stage to the center of the screen on >both mac and pc's, with both 800x600 and 1024X768 resolution. To do that I >tried to center my stage on both the mac and pc version of my project. When >I check the mac projector on both resolutions, it appears centered in both >cases. When I check it on a pc, it doesen't work : if I centered the screen >in 1024x768, then when I test the projector in 800x600 it appears eaten by >the lower right part of the screen. If I center the stage while in 800x600, >then when I test the projector in 1024x768, the stage appears in the higher >left part of the screen. It is not eaten up by the screen, so that is ok, >but it is not centered. > >Does anyone know anything about this issue? I'm sure there must be some >lingo to avoid this problem, but am I doing anything wrong in the first >place? > >Thanks in advance >-- >Alex Czetwertynski >Disciple Films Paris >www.disciplefilms.com [To remove yourself from this list, or to change to digest mode, go to http://www.penworks.com/LUJ/lingo-l.cgi To post messages to the list, email [EMAIL PROTECTED] (Problems, email [EMAIL PROTECTED]) Lingo-L is for learning and helping with programming Lingo. Thanks!]
