I've created a director movie on a PC which, when turned into a projecto,r
works fine. When I bring it over to the mac, however, it runs fine in
director, but when I go to create a mac projector it hits one section with
heavy lingo and messages come up saying that it cannot recognize commands
like blend and memberNum or it replaces any period in the script with hash
marks ie. sprite (8)#memberNum and then crashes the computer. As I said, it
works fine in director, but suffers all these problems when turned ito a mac
projector. Any ideas on what could be going on would be most appreciated.
Thanks
Iain Welland
_______________________________________________________________________
This message is confidential and is intended for the addressee only;
unless clearly stated that this disclaimer should not apply, this
e-mail is not intended to create legally binding commitments on
behalf of any company in the British Interactive Broadcasting
Holdings Limited group, nor do its contents reflect the corporate
views or policies of any such company. Any unauthorised disclosure,
use or dissemination, either whole or partial, is prohibited. If you
are not the intended recipient of the message, please notify the
sender immediately.
_______________________________________________________________________
[To remove yourself from this list, or to change to digest mode, go to
http://www.penworks.com/LUJ/lingo-l.cgi To post messages to the list,
email [EMAIL PROTECTED] (Problems, email [EMAIL PROTECTED])
Lingo-L is for learning and helping with programming Lingo. Thanks!]
