Hi I'm just about to port one of my prototypes in Flash to Director 8.5. It's a very heavily scripted and maths reliant concept and I'm hoping to speed things up considerably by doing this. Does anyone have any advice for doing this before I start? And specifically, is there any way of pulling a cast member from the cast using lingo and placing them on stage to be manipulated...rather like attachMovie() in Flash? Cheers Simon ______________________________________________________________ CONFIDENTIALITY NOTICE This communication and the information it contains is intended for the person or organisation to whom it is addressed. Its contents are confidential and may be protected in law. Unauthorised use, copying or disclosure of any of it may be unlawful. If you are not the intended recipient, please contact us immediately. The contents of any attachments in this e-mail may contain software viruses, which could damage your own computer system. While Marlborough Stirling has taken every reasonable precaution to minimise this risk, we cannot accept liability for any damage which you sustain as a result of software viruses. You should carry out your own virus checking procedure before opening any attachment. Marlborough Stirling plc, Registered No. 3008820, Allen Jones House, Jessop Avenue, Cheltenham, Gloucestershire, GL50 3SH Tel: 01242 547000 Fax: 01242 547100 http://www.marlborough-stirling.com The following companies are subsidiaries of Marlborough Stirling plc and are registered in England and Wales at the above address: Marlborough Stirling PLC, Registered No. 3008820 The Marlborough Stirling Group PLC, Registered No. 1855353 Marlborough Stirling Administration Limited, Registered No. 2341195 Metgem Limited, Registered No. 02341195 [To remove yourself from this list, or to change to digest mode, go to http://www.penworks.com/LUJ/lingo-l.cgi To post messages to the list, email [EMAIL PROTECTED] (Problems, email [EMAIL PROTECTED]) Lingo-L is for learning and helping with programming Lingo. Thanks!]
