Hi list, We are installing an interactive that will be displayed on a plasma screen. However on start up the screen needs to be switched on by control or by the button. We know of a piece of VB code that can send a message to the com port to force the plasma screen to switch on. Does anyone know if it is possible to do by lingo or is there an xtra available to do so?
Thank you Paul Fletcher Past Forward Limited, England, UK mailto:[EMAIL PROTECTED] http://www.pastforward.co.uk/ CONFIDENTIALITY AND DISCLAIMER NOTICE This email and any attachments are private and confidential. It is intended for the recipient only. If you are not the intended recipient, any use, disclosure, distribution, printing or copying of this email is unauthorised. You must not read, use or take any action in reliance on it. If you have received this email in error please notify the sender immediately by replying to this email and permanently delete the email from your computer. The contents of any attachments to this e-mail may contain software viruses which could damage your own computer system. While we have taken every reasonable precaution to minimise this risk, we cannot accept liability for any damage which you sustain as a result of software viruses. You should carry out your own virus checks before opening any attachments. [To remove yourself from this list, or to change to digest mode, go to http://www.penworks.com/LUJ/lingo-l.cgi To post messages to the list, email [EMAIL PROTECTED] (Problems, email [EMAIL PROTECTED]) Lingo-L is for learning and helping with programming Lingo. Thanks!]
