Hi Dave, > Now, I have Linrad running in CW mode (mode B), and am able to > process audio from the radio through Linrad. However, I have not > figured out how to do the same with the weak signal mode (A). When I > run mode A, I do not see anything on the waterfall display at all. > Then, for some unknown reason, I will see very bright lines appearing > as if something is being overdriven., but no signal line, even though > the radio is putting a carrier tone to Linrad. Is this an audio card > problem? It works fine in mode B, with expected waterfall display., > but not so in mode A.
There is no difference whatsoever between modes A and B. The software is exactly the same and what you observe is because of different parameters that are set for these modes. You could copy par_cw to par_wcw and all the other ones par_cw_wg to par_wcw_wg and so on to get identical results in modes A and B. The idea is that you would like different parameter sets for wcw (=EME) as compared to cw (terrestrial) with different sensitivity and processing delay. 73 Leif / SM5BSZ > > As usual, all help is appreciated. > > Dave, W5UN > > > > ############################################################# > This message is sent to you because you are subscribed to > the mailing list <linrad@antennspecialisten.se>. > To unsubscribe, E-mail to: <[EMAIL PROTECTED]> > To switch to the DIGEST mode, E-mail to <[EMAIL PROTECTED]> > To switch to the INDEX mode, E-mail to <[EMAIL PROTECTED]> > Send administrative queries to <[EMAIL PROTECTED]> > ############################################################# This message is sent to you because you are subscribed to the mailing list <linrad@antennspecialisten.se>. To unsubscribe, E-mail to: <[EMAIL PROTECTED]> To switch to the DIGEST mode, E-mail to <[EMAIL PROTECTED]> To switch to the INDEX mode, E-mail to <[EMAIL PROTECTED]> Send administrative queries to <[EMAIL PROTECTED]>