Thanks for replying. Brock from Redhat provided my answer. My /etc/chandev.conf was not correct. He provided a working example, I changed mine to match and the qeth came up. Thaks again, Al Schilla
-----Original Message----- From: Post, Mark K [mailto:[EMAIL PROTECTED] Sent: Saturday, February 28, 2004 8:18 PM To: [EMAIL PROTECTED] Subject: Re: RHEL qeth not loading Alan, What does /etc/chandev.conf and /etc/modules.conf look like? Mark Post -----Original Message----- From: Linux on 390 Port [mailto:[EMAIL PROTECTED] Behalf Of Alan Schilla Sent: Thursday, February 26, 2004 8:15 AM To: [EMAIL PROTECTED] Subject: RHEL qeth not loading I have just installed Redhat RHEL3 via FTP. The boot loader activates and uses my QDIO/QETH guest lan just fine but after installing and rebooting I recevie the folloing message: network: Setting network parameters: succeeded ifup: Cannot get driver information: Operation not supported I then try a modprobe qeth and receive the following: qdio: loading QDIO base support version 2 ($Revision: 1.145 $/$Revision: 1.57 $) qeth: loading qeth S/390 OSA-Express driver ($Revision: 1.337 $/$Revision: 1.113 $/$Revision: 1.42 $:VLAN) /lib/modules/2.4.21-4.EL/kernel/drivers/s390/net/qeth.o: init_module: No such de vice Hint: insmod errors can be caused by incorrect module parameters, including inva lid IO or IRQ parameters. You may find more information in syslog or the output from dmesg /lib/modules/2.4.21-4.EL/kernel/drivers/s390/net/qeth.o: insmod /lib/modules/2.4 .21-4.EL/kernel/drivers/s390/net/qeth.o failed qdio: QDIO base support version 2 ($Revision: 1.145 $/$Revision: 1.57 $): module removed /lib/modules/2.4.21-4.EL/kernel/drivers/s390/net/qeth.o: insmod qeth failed Anyone have any ideas what is missing or is misconfigured? I am at a loss especially since the installation boot kernel works fine but the installed version does not. Thanks, Al Schilla State of Minnesota
