I have a z800 with 1 IFL processor. in the panel for (Customize Image Profiles) I show an entry in the pull down for MODE that is (Linux Only). You must select this. NOTE: refer to page 3-60 in GA22-7236-07
>>> [EMAIL PROTECTED] 10/25/04 09:37AM >>> Hi, We just had two IFL engines installed on our z900 machine. When we look at the CPs defined, I can see the standard engines, and two engines that show CF on the icons. When we go the activation profile for the LPAR that we are going to run Linux in, I do not see any LINUX options for the CPs, just the dedicate for standard engines, and the dedicate for coupling facility engines. Do I just use this CF option, or should I also have a Linux CP option? Thanks, Ken Vance Amadeus ---------------------------------------------------------------------- For LINUX-390 subscribe / signoff / archive access instructions, send email to [EMAIL PROTECTED] with the message: INFO LINUX-390 or visit http://www.marist.edu/htbin/wlvindex?LINUX-390 ---------------------------------------------------------------------- For LINUX-390 subscribe / signoff / archive access instructions, send email to [EMAIL PROTECTED] with the message: INFO LINUX-390 or visit http://www.marist.edu/htbin/wlvindex?LINUX-390
