I have just completed setting up a hipersocket connection to zVM on a Z800. We are not running Linux under VM, we have an IFL processor and Linux running in an LPAR. I have some documentation that I created for myself. I also setup an explicit route on Linux so that I can bypass the intranet and use the hipersocket for any communications to the VM system. If you would like the documentation email me at [EMAIL PROTECTED] and I will email it back to you. I tried to send it but the service said the message was to long.
Good Luck!!!! Mike Lovins System Support/LAN Assiciate Consultant Ciy of Tulsa, Tulsa, Oklahoma >>> [EMAIL PROTECTED] 10/25/04 03:20AM >>> You configuration looks : world - qdio osa card - vm/TCPIP - hypersocket - LINUX. Mark , Pieter and Alan already outlined that hipersocket is not a p2p (but this is probably not the problem in this case) and pointed to verify routing problem both from linux to the world and viceversa. I only suggest to verify the routing into the osa card. OSA cards route only registered addresses to their unit addresses, and unregistered addresses to PRIMARY ROUTER (if defined) . So : - define [EMAIL PROTECTED] as PRIROUTER (if none is already defined) - OR try to use vmTCPIP as a PROXYARP (not sure you will be able, vmTCPIP ifconfig sees the link as a point2point , but the profile definition is not for a p2p, it is for an hypersocket !). hoping I didn't understand the configuration, and it helps, Franco Mignogna , IBM Italy, IT specialist ---------------------------------------------------------------------- For LINUX-390 subscribe / signoff / archive access instructions, send email to [EMAIL PROTECTED] with the message: INFO LINUX-390 or visit http://www.marist.edu/htbin/wlvindex?LINUX-390 ---------------------------------------------------------------------- For LINUX-390 subscribe / signoff / archive access instructions, send email to [EMAIL PROTECTED] with the message: INFO LINUX-390 or visit http://www.marist.edu/htbin/wlvindex?LINUX-390
